エラー#17


Error # 17 "No response from USB channel. The application will attempt to reconnect to the Engraver. Following reconnection, run the print job again." [USBチャンネルから応答がありません。アプリケーションはレーザー加工機に再接続しようとします]

 

 

 

対処方法


■レーザー加工機の電源をOFFにし、パソコンのUCP(Universal Control Panel)を閉じて、USBケーブルを再接続します。UCPを起動させて、レーザー加工機の電源をONにします。